Ford Escape: Electronic Feature Group / Multifunction Electronic Modules

Removal and Installation - Image Processing Module A (IPMA)

Removal Release the clips and remove the IPMA cover. Disconnect the electrical connector. Release the tabs and remove the IPMA ...

Description and Operation - Module Controlled Functions - Component Location

Item Description 1 BCMC 2 BCM 3 PDM 4 RTM 5 DDM ..

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Piston Inspection

Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod. NOTE: Make sure the oil ring hol..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Parking Assist Control Module (PAM)

Removal All vehicles NOTE: If installing a new PAM , it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new PAM after installation. Using a diagnostic scan tool, begin the PMI process for the PAM following the onscreen instructions. Remove the floor console. R..