Other information:
Removal
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
Disconnect the electrical connectors.
Remove the rear parking aid sensor.
Release the tabs.
Remove the sensor.
Installation
NOTE:
Make sure that the isolator rings are installed cor..
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if the SODL or SODR is being replaced.
NOTE:
This procedure can be used for all locations of the component.
Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19..