Ford Escape: Multifunction Electronic Modules / Description and Operation - Module Controlled Functions - Component Location

Multifunction Electronic Modules

..

Description and Operation - Module Controlled Functions - Overview

BCM The BCM controls the following: Ambient lighting Battery management function Delayed accessory function Dimmable backlighting Door Lock LED Exterior lighting Fog lamps (if equipped) Headlamps Heated rear windows Heated exterior mirrors Horn relay control Interior lighting Keypad switch and illumination PATS ..

Other information:

Ford Escape 2020-2025 Service Manual: Removal and Installation - Brake Caliper

Removal   WARNING: Service actions on vehicles equipped with electronic brake booster and electronic parking brakes may cause unexpected brake application, which could result in injury to hands or fingers. Put the brake system into service mode prior to servicing or removing any brake components. Failure to follow this instruction may result in serious personal injury. NOTICE: ..

Ford Escape 2020-2025 Service Manual: General Procedures - Module Programming

Check NOTE: Perform the following pre-checks to make sure module programming completes without errors. Start the programming session in Key OFF, Engine OFF and prior to initiating programming, turn to KOEO . Make sure the vehicle battery is fully charged or is connected to a battery charger. The battery state of charge should be 12.6 - 13.6 volts during vehicle programming. ..