Ford Escape: Electrical Distribution / Module Configuration

Removal and Installation - Gateway Module A (GWM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module...

Description and Operation - Module Configuration - System Operation and Component Description

System Operation Programmable Module Installation (PMI) PMI is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started...

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - High Voltage Battery Junction Box - Plug-In Hybrid Electric Vehicle (PHEV)

Removal   WARNING: To prevent the risk of high-voltage shock, always follow precisely all warnings and service instructions, including instructions to depower the system. The high-voltage system utilizes approximately 450 volts DC, provided through high-voltage cables to its components and modules...

Ford Escape 2020-2026 Service Manual: General Procedures - Finish Panel Repair

Repair NOTE: Mouldings located on the front and rear window frames may experience minor scratches from vehicle shipment or car wash racks. The imperfections may be repaired instead of replacing components by following the steps below. NOTE: Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced...