Ford Escape: Body and Paint / Interior Trim and Ornamentation

Removal and Installation - Rear Gate Trunk Module (RGTM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component...

Removal and Installation - A-Pillar Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH (left hand) shown, RH (right hand) similar. Disconnect the tether clips from the A-pillar trim panel...

Other information:

Ford Escape 2020-2026 Service Manual: Diagnosis and Testing - Engine Temperature

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0116:00 Engine Coolant Temperature Sensor 1 Circuit Range/Performance: No Sub Type Information GO to Pinpoint Test ..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Drive Pinion Flange

Special Tool(s) / General Equipment 205-126 (T78P-4851-A) Holding Fixture, Drive Pinion Flange 205-233 (T85T-4851-AH) Installer, Drive Pinion FlangeTKIT-1985-FH-1  303-249Remover, Crankshaft Timing Pulley Transmission Jack Flat-Bladed Screwdriver Wooden Block Materials Name Specification Motorcraft® Premium Long-Life GreaseXG-1-E1 ESA-M1C..