Ford Escape: Maintenance / Engine Oil
Engine Oil Dipstick Overview

- Minimum.
- Maximum.
Checking the Engine Oil Level
- Make sure that your vehicle is on level
ground.
- Check the oil level before starting the
engine, or switch the engine off after
warming up and wait 10 minutes for
the oil to drain into the oil pan.
- Remove the dipstick and wipe it with
a clean, lint-free cloth.
- Reinstall the dipstick and make sure it
is fully seated.
- Remove the dipstick again to check the
oil level.
Note: If the oil level is between the
maximum and minimum marks, the oil level
is acceptable. Do not add oil.
- If the oil level is at the minimum mark,
immediately add oil.
- Reinstall the dipstick. Make sure it is
fully seated.
Note: The oil consumption of new engines
reaches its normal level after approximately
3,000 mi (5,000 km).
Adding Engine Oil
WARNING: Do not remove the filler
cap when the engine is running.
WARNING: Do not add engine oil
when the engine is hot. Failure to follow
this instruction could result in personal
injury.
Do not use supplemental engine oil
additives because they are unnecessary
and could lead to engine damage that the
vehicle warranty may not cover.
- Clean the area surrounding the engine
oil filler cap before you remove it.
- Remove the engine oil filler cap.
- Add engine oil that meets our
specifications.
- Reinstall the engine oil filler cap. Turn
it clockwise until you feel a strong
resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Immediately soak up any oil spillage
with an absorbent cloth.
Resetting the Engine Oil Change Reminder
Use the information display controls on
the steering wheel to reset the oil change
reminder.
From the main menu scroll to:

Engine Oil Capacity and Specification
For filling information, please refer to the
Capacities and Specifications section of
your owner's manual.
Windshield washer fluid reservoir: See Adding Washer Fluid.
Low temp coolant cap: See Checking the Coolant.
High temp coolant cap: See Checking the Coolant...
When the engine is cold, check the
concentration and level of the coolant at
the intervals listed in the scheduled
maintenance information.
Note: Make sure that the coolant level is
between the minimum and maximum marks
on the coolant reservoir...
Other information:
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Spherical Cutter
Air Body Saw
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055
-
Flexible Foam Repair3M™ 08463, LORD Fus..
Overview
Power Window Operation
The
power windows operate only when the ignition is on, or up to 10 minutes
after the ignition is changed from on to off while the front driver and
passenger doors remain closed. Standard power window features include
one-touch down operation (driver door window only) when the driver
window control switch is momentarily pressed to the second detent and
r..