Other information:
Check
NOTE:
Perform the following pre-checks to make sure module programming completes without errors.
Start the programming session in Key OFF, Engine OFF and prior to initiating programming, turn to KOEO .
Make sure the vehicle battery is fully charged or is
connected to a battery charger. The battery state of charge should be
12.6 - 13.6 volts during vehicle programming.
..
Special Tool(s) /
General Equipment
Wooden Block
Removal
NOTE:
If the catalytic converter is not being replaced, the HO2S
and the catalyst monitor sensor do not need to be removed from the
catalytic converter. Disconnecting the electrical connectors is still
necessary.
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEU..