Ford Escape: Exterior Lighting / Removal and Installation - Front Turn Signal Lamp Bulb
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front turn signal lamp bulb cover.
-
Rotate the front turn signal lamp bulb holder
counterclockwise and remove the turn signal bulb holder from the
headlamp assembly.
-
Remove the front turn signal lamp bulb.
Installation
-
To install, reverse the removal procedure.
Removal
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
Remove the front fog lamp...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the center registers.
Refer to: Center Registers (412-00 Climate Control System - General Information, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
204-161
(T97P-1175-A)
Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2
205-D070
(D93P-1175-B)
Remover, Front Wheel Hub
Tie Rod End Remover
Removal
Remove the wheel and tire...
What Is the Tire Sealant and Inflator Kit
The kit consists of an air compressor to
re-inflate the tire and a canister of sealing
compound that will effectively seal most
punctures. This kit will provide a temporary
tire repair allowing you to drive your vehicle
up to 120 mi (200 km) at a maximum
speed of 50 mph (80 km/h) to reach a tire
service location...