Ford Escape: Seatbelt Systems / General Procedures - Seatbelt Cleaning
Cleaning
WARNING:
Do not bleach or re-dye the seatbelt webbing, as the webbing
may weaken. Failure to follow this instruction may increase the risk of
serious personal injury or death in a crash.
-
Refer to the owner's literature for information on
seatbelt care and the recommended cleaning solution to use. Follow the
manufacturer's instructions provided with the cleaning solution.
Repair
NOTE:
If the seatbelt webbing does not extract from the seatbelt
retractor from the stowed position, this may be due to a normal
condition which happens when the seatbelt retracts at a high rate of
speed...
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door.
Torque:
8 lb.in (0.9 Nm)
Remove the upper belt moulding screw at rear of the door...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. SGM
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
APIM
U0293:00
Lost Communication With Hybrid/EV Powertrain Control Module 'A': No Sub Type Information
GO to Pinpo..