Ford Escape 2020-2026 Service Manual / Powertrain / Engine / Electronic Engine Controls / Removal and Installation - Knock Sensor (KS)
Ford Escape: Electronic Engine Controls / Removal and Installation - Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the intake manifold.
Refer to: Intake Manifold (303-01C Engine, Removal and Installation).
-
Remove the bolt and the KS .
Torque: 177 lb.in (20 Nm)
.jpg) |
Installation
-
To install, reverse the removal procedure.
Removal and Installation - Manifold Absolute Pressure and Temperature (MAPT) Sensor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the electrical connector, remove the retainer and the MAP sensor...
Other information:
Ford Escape 2020-2026 Service Manual: Removal and Installation - Brake Master Cylinder - Vehicles With: Vacuum Brake Booster
Removal NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water. NOTE: Removal steps in this procedure may contain installation details. Remove the battery. Refer to: Battery (414-01 Battery, Mounting and Cables, Removal and Installation)...
Ford Escape 2020-2026 Owners Manual: Drive Belt Routing Overview - 1.5L EcoBoost™ and 2.0L EcoBoost™
1.5L EcoBoost™ 2.0L EcoBoost™ The long drive belt is on the first pulley groove closest to the engine. The short drive belt is on the second pulley groove farthest from engine. ..
Categories
- Manuals Home
- 4th Generation Ford Escape Owners Manual
- 4th Generation Ford Escape Service Manual
- General Procedures - Brake Service Mode Activation and Deactivation
- Electric Parking Brake
- Power Outlet - Vehicles With: 12V Power Outlet
- New on site
- Most important about car
Sitting in the Correct Position
When you use them properly, the seat, head restraint, seatbelt and airbags will provide optimum protection in the event of a crash.
Copyright © 2026 www.fordescape4.com