Ford Escape: Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Rear Antenna
Removal
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the keyless entry rear antenna.
-
Disconnect the keyless entry rear antenna electrical connector.
-
Release the retaining clips and remove the keyless entry rear antenna.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
Remove the front door upper moulding...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense. Use the same or equivalent parts if
replacement is necessary. Do not use a replacement part of lesser
quality or substitute design...
Special Tool(s) /
General Equipment
100-002
(TOOL-4201-C)
Holding Fixture with Dial Indicator Gauge
Inspection
NOTE:
Driveline vibration exhibits a higher frequency and lower
amplitude then high-speed shake. Driveline vibration is directly related
to the speed of the vehicle and is noticed at various speeds...