Ford Escape: Engine / Electric Powertrain Control

Removal and Installation - Variable Camshaft Timing (VCT) Oil Control Solenoid

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the valve cover. Refer to: Valve Cover (303-01C Engine, Removal and Installation)...

Description and Operation - Electric Powertrain Control - Component Location

Inverter System Controller Item Description 1 Inverter System Controller High Voltage Battery Coolant Temperature Sensor Item Description 1 High Voltage Battery Coolant Temperature Sensor ..

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Coolant Pump

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling, General Procedures). Disconnect the electrical connector. Release the clamps and disconnect the coolant hoses. Use the General Equipme..

Ford Escape 2020-2026 Service Manual: General Procedures - Air Conditioning (A/C) System Recovery, Evacuation and Charging - 2.5L Duratec – Hybrid (121kW/164PS) (BG)

Special Tool(s) / General Equipment Refrigerant Identification Equipment Check NOTE: For all equipment, follow the manufacturer's instructions. Follow and inspect all charging instructions. Start and run the engine at idle until normal operating temperature is reached. Set Heaters front and rear (if equipped) to full hot. Connect the following it..