Ford Escape: Remote Convenience / Diagnosis and Testing - Universal Transmitter
Global Customer Symptom Code (GCSC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom |
Action |
Driver Aid & Information >
Universal Remote >
Performance >
Inoperative |
GO to Pinpoint Test A |
Symptom Chart(s)
Symptom Chart: Universal Home Transmitter
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom Chart
Condition
|
Actions
|
The universal transmitter is inoperative
|
GO to Pinpoint Test A
|
Pinpoint Tests
PINPOINT TEST A: UNIVERSAL TRANSMITTER IS INOPERATIVE
Normal Operation and Fault Conditions
REFER to: Universal Transmitter - Overview (419-02 Remote Convenience, Description and Operation).
Possible Sources
- Interior lighting concern
- Universal transmitter (part of the LH sun visor)
|
A1 CHECK FOR VOLTAGE TO THE UNIVERSAL TRANSMITTER |
-
Check the illumination of the universal transmitter by pressing one of the buttons.
Does the indicator on the universal transmitter illuminate?
|
A2 PROGRAM A HAND-HELD TRANSMITTER TO THE UNIVERSAL TRANSMITTER |
-
NOTE:
The customer's hand-held transmitter is required when programming the universal transmitter.
Program the universal transmitter. Refer to the Owner's Literature.
Does the universal transmitter program successfully?
Yes |
The universal transmitter is OK. VERIFY the receiver unit operates correctly.
|
No |
INSTALL a new LH sun visor.
|
|
A3 CHECK THE OPERATION OF THE LH (LEFT-HAND)
VANITY MIRROR LAMP |
-
Verify the operation of the LH vanity mirror lamp.
REFER to: Interior Lighting (417-02 Interior Lighting, Diagnosis and Testing).
Does the LH vanity mirror lamp operate correctly?
Yes |
INSTALL a new LH sun visor.
|
No |
Diagnose the interior lighting concern. REFER to: Interior Lighting (417-02 Interior Lighting, Diagnosis and Testing).
|
|
System Operation
Universal Transmitter
The universal transmitter learns a hand-held transmitter radio
frequency code and stores the code in memory...
Other information:
Switching the Turn Signal Lamps On and Off
Push the lever up or down to
switch the turn signal lamps on.
Set the lever to the middle position to
switch the turn signal lamps off.
Note: Tap the lever up or down to make the
turn signal lamps flash three times.
Switching the Daytime Running Lamps On and Off - Vehicles With: Daytime
Running Lamps (DRL)
WARNING: The daytime running
lamps system ..
System Operation
BLIS ® and CTA
System Diagram - Vehicles Without Door Modules
Item
Description
1
SODL
2
GWM
3
SCCM
4
PAM
5
IPC
6
APIM
7
PCM
8
TRM (If equipped)
9
BCM
10
ACM
11
LH exterior mirror
12
DSP Module
13
10 Speaker System
14
..