Ford Escape: Instrument Panel and Interior Switches Illumination / Description and Operation - Instrument Panel and Interior Switches Illumination - Overview
Overview
Dimmable Illumination
Dimmable illumination provides backlighting to switches and control components when the parking lamps are on. The instrument panel dimmer switch is used to increase or decrease the level of intensity for the dimmable backlit components. The BCM is the master module that controls the dimmable illumination.
Dimmable backlit switches and components are:
- Headlamp switch
- EPB switch
- Overhead console switches (front interior lamp)
- Media hub
- Start-stop switch
- Hazard flasher switch
- Auto-start-stop deactivation switch
- PAD indicator/defrost switch
- Roof opening panel switch
- Sunshade switch
- Steering wheel switches
- Power window switches
- Door lock switches
When the autolamp feature activates during the daytime, the message center illumination remains at full intensity and can not be dimmed using the instrument panel dimmer switch. If the vehicle travels under a bridge or through a tunnel and a low level of ambient light is detected, the illumination brightness of the message center changes to the last level set by BCM . The message center illumination changes back to full intensity when the intense ambient light is restored.
Description and Operation - Instrument Panel and Interior Switches Illumination - System Operation and Component Description
System Operation
System Diagram - Networked Illumination
Item
Description
1
APIM
2
Light Sensor
3
ACM
4
IPC
5
DDM
6
PDM
7
BCM
8
RF Door Lock Switch
9
RF Door Window Control Switch
10
LF Door Window Control Switch
11
RR Door Window Control Switch
12
LR Door Window Con..
Other information:
Ford Escape 2020-2026 Service Manual: Removal and Installation - Charge Status Indicator (CSI) - Plug-In Hybrid Electric Vehicle (PHEV)
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the LH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels). Disconnect the CSI electrical connector, detach the retainer and position the wire harness aside. Open the charge port door. Rele..
Ford Escape 2020-2026 Service Manual: Diagnosis and Testing - Electric Powertrain Control
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. SGM REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action APIM U0293:00 Lost Communication With Hybrid/EV Powertrain Control Module 'A': No Sub Type Information GO to Pinpo..
Categories
- Manuals Home
- 4th Generation Ford Escape Owners Manual
- 4th Generation Ford Escape Service Manual
- Removal and Installation - All-Wheel Drive (AWD) Module - 1.5L EcoBoost (132kW/180PS) – I3 (Y1)/2.0L EcoBoost (177kW/240PS) – MI4
- All-Wheel Drive
- Accessing the Trip Computer. Resetting the Trip Computer
- New on site
- Most important about car
Adjusting the Seatbelts During Pregnancy
WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.
