Ford Escape: Seatbelts / Adjusting the Seatbelt Height
WARNING: Position the seatbelt
height adjuster so that the seatbelt rests
across the middle of your shoulder.
Failure to adjust the seatbelt correctly
could reduce its effectiveness and
increase the risk of injury in a crash.

- Press the button and slide the height
adjuster up or down.
- Release the button and pull down on
the height adjuster to make sure it is
locked in place.
WARNING: Always ride and drive
with your seatback upright and properly
fasten your seatbelt. Fit the lap portion
of the seatbelt snugly and low across
the hips...
How Does the Seatbelt Reminder Work
WARNING: The system will only
provide protection when you use the
seatbelt correctly.
This system monitors all seating positions
and provides audio and graphic feedback...
Other information:
Special Tool(s) /
General Equipment
307-805Alignment Pins (2)
Ford Diagnostic Equipment
Removal
NOTE:
This step is only necessary when installing a new transmission or ISC (Inverter System Controller).
Download the module information to the diagnostic tool using the Programmable Modules Installation routine...
The RDU is available with 2.58 drive ratio.
Rear Drive Axle and Differential
The rear drive axle and differential unit (RDU ) is a cast aluminum
differential assembly located in the rear of the vehicle consisting of
the following components:
Crown wheel and pinion
An electrically activated and mechanically engaged
clutch pack acting on the rear drive axles, that applies or removes..