Ford Escape: General Information / Description and Operation - Engine Cooling System Health and Safety Precautions
WARNING:
Always allow the engine to cool before opening the cooling
system. Do not unscrew the coolant pressure relief cap when the engine
is operating or the cooling system is hot. The cooling system is under
pressure; steam and hot liquid can come out forcefully when the cap is
loosened slightly. Failure to follow these instructions may result in
serious personal injury.
WARNING:
Do not work on the fuel system until the pressure has been
released and the engine has cooled. Fuel in the high-pressure fuel
system is hot and under very high pressure...
WARNING:
Before working on or disconnecting any of the fuel tubes or fuel
system components, relieve the fuel system pressure to prevent
accidental spraying of fuel...
Other information:
Special Tool(s) /
General Equipment
310-250Disconnect Tool, Fuel LineTKIT-2012A-FLTKIT-2012A-ROW
Disconnect
NOTICE:
When reusing liquid or vapor tube connectors, make sure to
use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the
tube or connector retaining clip can occur...
System Operation
Item
Description
1
BCM
2
Roof Opening Panel Control Switch
3
Sliding Glass Motor / Module
4
Shade Motor
Roof Opening Panel Operating System
The accessory delay relay in the BCM
supplies voltage through fuse F6 (10A) to the sliding glass motor /
module allowing the motors to respond to roof opening panel control
sw..